JIS-K7199, ASTM-D3835, ISO-11443

This tester evaluates the flow feature of molten plastic during the forming process. The molten test specimen inside the cylinder that is set at a specific temperature will be extruded from the capillary die. During the extrusion, the shear stress and the shear viscosity is detected to measure the melt viscosity of the test specimen. The tester is equipped with an automatic cleaning system which enables the operator to continuously run 1 test cycle (option of 3 test cycles). The tester can be chosen between the light load type and the heavy load type according to the test specimen’s maximum load.

 

Maximum Load

Max. 10 kN

Load Measuring

Load Cell: Max. 10 kN (Scale 0.1 N)

Ram Speed

0.5 to 500 mm/min

Capillary Die

φ0.5 to φ2 mm, L/D (To be specified)

Piston

φ9.510 ± 0.005 mm, L6.35 ± 0.10 mm

Cylinder

Inner φ9.550 ± 0.025 mm, L160 mm

Temperature Range

Max. 400 °C

Software

Windows Compatible

Accessories

Cleaning Rod (Die & Cylinder), Solvent Cleaning Device,

Specimen Cup, Cup Holder, Infundibulum,
Die Gauge, Spirit Level, Dust Box,
Gauze, Air Gun, Ratchet Wrench

Option

Hastelloy Spec, Specimen Purging Device, Specimen Drying Device,
Air Compressor, Temperature Calibration Device,
Exhaust Fan, Smoke-Detection Sensor

Power Source

AC 200 V, 1-Phase, 10 A, 50/60 Hz

Air Source

0.5 MPa or More

Dimensions/Weight (Approx.)

W620 × D600 × H1,120 mm/ 150 kg